Table of Contents
Advertisement
Available languages
Available languages
Installation
CHOOSING THE PROPER LOCATION FOR YOUR DEHUMIDIFIER
• Use the dehumidifier in a
basementto help prevent
moisturedamage.
• Use the dehumidifierin laundry
drying, bathing, and dishwashing
areaswhich have excessive
moisture.
• Use the dehumidifierto prevent
moisturedamage where books
are stored.
INSTALLING THE DEHUMIDIFIER
PROPERLY
1. Allow at least 12 inches of space on all sides of the unit for good air circulation.
2. Install your dehumidifier on a floor only.
3. Lift the bucket and place it in the dehumidifier, making sure the slots
on the bottom side of the bucket are positioned correctly.
4. Swivel casters allow you to move the dehumidifier easily.
THE CLEANING OF BUCKET
1. Pull out the bucket cover.
2. Brush off the residue in the
bucket.
Clean the bucket by
wiping with a brush or a cloth
dampened in a mild detergent
solution.
3.
Close the cover.
Push the tabs on the top
of the bucket cover when installing
the bucket cover.
Owner's Manual
13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 54351 - 35 Pint Dehumidifier and is the answer not in the manual?
Questions and answers
i want to collect water only in the bucket and not go to hole outlet is there a special way to change it
To set the Kenmore 54351 - 35 Pint Dehumidifier to collect water only in the bucket instead of the hose outlet, follow these steps:
1. Remove the drain hose if it is attached.
2. Ensure the drain hole cover is in place to block the hose outlet.
3. Make sure the water bucket is properly installed in its correct position.
The dehumidifier will then collect water in the bucket, and you will need to empty it manually when full.
This answer is automatically generated