Selecting the Line Mode
If the line is connected to a low voltage system such as a PBX, set to "B".
Otherwise the unit may not ring and the Visual Call Waiting (Call Waiting
ID) Service may not be accessible (p. 42).
Your phone comes from the factory set to "A".
Make sure that the handset is in the stand-by mode.
1
Press
(FUNCTION/EDIT)
2
Press
or
points to "Program".
3
Press
OK
4
Press
or
points to "Set line mode".
5
Press
OK
6
Press
or
(Save key).
OK
• A beep sounds.
• The display will return to the function list.
To return to the stand-by mode, press
or wait for 60 seconds.
(EXIT/CH)
• You can exit the programming mode any time by pressing
• If 3 beeps sound and the display shows "Save error", move closer to
the base unit and try again. If "Save error" is still displayed, place the
handset on the base unit. Start again from step 1.
If a power failure occurs, the mode will return to the factory preset (A).
Reprogram if necessary.
.
repeatedly until the arrow
(Yes key).
repeatedly until the arrow
(Yes key).
to select "B" or "A". Press
H
Redial
Directory
∨∧
OK=Yes
Ringer volume
H
Program
∨∧
OK=Yes
H
Save directory
Set flash time
∨∧
OK=Yes
Save mailbox#
H
Set line mode
∨∧
OK=Yes
Line mode
∨∧
OK=Save
Line mode
.
(EXIT/CH)
:A
:B
15