Table of Contents
Advertisement
Before Requesting Help
Problem
You cannot program items,
such as the dialing mode.
Previously programmed
information is erased.
You cannot store a name and
phone number in the directory.
While programming or
searching, the unit starts to
ring and stops the
program/search.
The unit does not display the
caller's name and/or phone
number.
The display goes to the
stand-by mode while viewing
the Caller List.
When a second call is
received during a
conversation, the unit does not
display the new caller's name
and/or phone number.
50
Remedy
• Programming is not possible while the
unit is in the talk mode or when viewing
caller information.
• Do not pause for over 60 seconds
while programming.
•
or
may have been pressed
when you picked up the handset. Press
and try again.
(EXIT/CH),
• If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
• You cannot store an item in the
directory while the unit is in the talk
mode.
• Do not pause for over 60 seconds
while storing.
• To answer the call, press
Start again from the beginning after
hanging up.
• Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
• Other electrical appliances connected
to the same outlet may be interfering
with the Call Display information.
• Telephone line noise may be affecting
the Call Display information.
• Do not pause for over 60 seconds
while searching.
• The line mode selection is incorrect.
See page 15.
.
(TALK)
Advertisement
Table of Contents
