Flash Button - Panasonic TG2550 - 2.4 Gigarange Cordless Phone Operating Instructions Manual

FLASH Button

Pressing
(CALL!WAIT/FLASH)
host PBX such as transferring an extension call or accessing special
telephone services (optional) such as call waiting.
Selecting the flash time (call waiting time)
The flash time depends on your telephone exchange or host PBX.
You can select from flash times (call waiting times): "700, 600, 400, 300,
250, 110, 100 or 90 ms (milliseconds)" using the handset near the base
unit. Your phone comes from the factory set to "700 ms".
Make sure that the handset is in the stand-by mode.
1
Press
(FUNCTION/EDIT)
2
Press or
points to "Program".
3
Press
OK
4
Press or
points to "Set flash time".
5
Press
OK
6
Press or
7
Press
OK
• A beep sounds.
• The display will return to the function list. To return to the stand-by
mode, press
• You can exit the programming mode any time by pressing
• If 3 beeps sound and the display shows "Save error", move closer to
the base unit and try again. If "Save error" is still displayed, place the
handset on the base unit. Start again from step 1.
• If you are connected via a PBX, a longer flash time may be necessary to
use PBX functions (transferring a call etc.). Consult your PBX installer for
the correct setting.
If a power failure occurs, the setting will return to the factory preset
(700 ms). Reprogram if necessary.
allows you to use special features of your
.
repeatedly until the arrow
(Yes key).
repeatedly until the arrow
(Yes key).
repeatedly until the desired time is displayed.
(Save key).
or wait for 60 seconds.
(EXIT/CH)
Ringer volume
H
Program
∨∧
OK=Yes
Save directory
H
Set flash time
∨∧
OK=Yes
Flash time
:700ms
∨∧
OK=Save
.
(EXIT/CH)
41