Spectrum Industries 55149 Assembly Instructions

Assembly Instructions
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts or
accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
(1) 0181379
Acrylic lower
logo panel
(1) 0181552
Bracket
(1) 0181492
Metal panel
1
Remove existing metal panel
1. If your lectern has an existing lower logo panel remove it from the hinged panel.
2. Tip the existing metal panel up and remove from hinge points.
(4) 0194092
3/4" x 3/4"
brushed stainless
standoff
(4) 0107892
10-24 x 1/4"
SHCS
(2) 021587
8-32 x 1/2" PHMS
(silver)
2
(2) 051696
1. Slide the bracket behind hinged panel as shown.
8-32 x 1" PHMS
2. Hook the new metal panel onto the lower edge of the hinged panel and
(black)
"lock" them together by pinching them together at the two hinge points.
3. Align the top (2) mounting holes of all three pieces and secure with
(2) 8-32 x 1/2" PHM screws.
Hinged
panel
(2) 8-32 PHMS
Note: Use 021587 for
silver/champagne metal or
051696 for black metal
2
Customized Lower Acrylic Logo Panel
for Honors Lectern
55149
Assembly tip: Do not tighten component fasteners completely
until all have been installed. Keeping them loose will help with
alignment between parts during assembly.
Assemble new metal panel
1
4mm
Hinged
panel
3
0199733R1 Page 1 of 2