Icom IC-02A/AT/E Instruction Manual page 48

SAS
Problem
Possible Cause Solution
. No modulation.
(When using external
microphone.)
Bad connection of the MIC con-
nector.
1 |
Check the connection of the MIC
connector and correct any pro-
blems.
. The receive mode func-
tions properly and your
signals are transmitted,
but you are unable to
make a contact with
another station.
The. set is in. DUPLEX: mode:
(When desiring SIMPLEX mode.)
The set is in SIMPLEX mode.
(When desiring DUPLEX mode.)
Improper frequency separation or
input/output frequencies of the
repeater.
Clear the DUPLEX mode by push-
ing '""#" key, then ''*'' key in the
DIAL mode.
Set the proper frequency separation
according to the repeater input/
output frequencies.
Set the proper frequency separation
according to the repeater input/
output frequencies.
. The programmed scan
does not function.
The set is in the MEMORY CHAN-
NEL mode.
The frequencies memorized in M5
and M6 are the same, or their
difference is less than the frequency
step rate.
Push the ''A"' key to set in DIAL
mode.
Memorize frequencies with a dif-
ference of more than the frequency
step rate into M5 and M6.
. All key functions are
disabled.
The LOCK function is engaged.
The CALL KEY function is engaged.
Clear the LOCK function by push-
ing the "'D" key while depressing
the ''"FUNC" key.
Clear the CALL KEY function by
pushing the "A" key.
—