Icom IC-02A/AT/E Instruction Manual page 26

PRIMARY FUNCTION SECONDARY FUNCTION
KEY FUNCTION KEY FUNCTION
Sets the radio in the memory channel Writes the displayed frequency into a
clLy mode. pire memory channel.
Push the key, then a desired channel Push the key, then a desired channel
number
von
number to store the displayed frequency.
|
Sets the radio in the memory scan mode. Sets the radio in the programmed scan
Cy S T ; mode.
cans all memories. rMS/ PS |
Scans between the frequencies memo-
rized in channel 5 and channel 6 with
specified steps.
Selects the frequency memorized in Cancels any key entries to prevent
aw MEMORY CHANNEL 3. Prete accidental key operation.
ven At this time, any key entries are can- Rey To clear this function, push this key
celled except the ''A'' key to clear this again while depressing the "FUNC" key.
function.
|
6-4 DIAL MODE
(1) SETTING FREQUENCY (1) To set an operating frequency, push four digit keys representing
the frequency desired, beginning with the MHz and ending with
the kHz digit. (IC-O2E: three digit keys beginning with the MHz
and ending with the 10kHz digit.)