Guardian Fall Protection CB-1-B Instruction Manual page 3

Introduction
Thank you for purchasing a Guardian Fall
Protection CB-1-B. This manual must
be read and understood in its entirety,
and used as part of an employee
training program as required by OSHA
or any applicable state agency.
This and any other included instructions
must be made available to the user of
the equipment. The user must understand
how to safely and effectively use the
CB-1-B, and all fall safety equipment
used in combination with the CB-1-B.
Applicable Safety Standards
When used according to instruction specifications, this product meets or exceeds all applicable OSHA 1926.502,
OSHA 1910.140, ANSI Z359.18-2017, and ANSI A10.32-2023 standards for fall protection, depending on application
(see below). This product has been tested in compliance with the requirements of ANSI/ASSE Z359.7. Testing only
covers hardware and does not extend to the anchorage or substrate to which this product is attached.
Applicable standards and regulations depend on the type of work being done, and also might include
state-specific regulations. Consult regulatory agencies for more information on personal fall arrest systems and
associated components.
CB-1-B Anchors do not comply with ANSI/IWCA I-14.1-2001 Section 9 requirements for tie-back/suspension
anchorages for window washing or facade maintenance equipment.
CB-1-B Anchors do not comply with CalOSHA section 3291 (f) for roof tie-back/suspension anchorages, which
are required on all buildings in California above 36' (or three stories), with certain rare exceptions.
Contact Guardian's Engineered Services Group (ESG) for more information or for anchors compliant with
CalOSHA and/or IWCA standards.
PRODUCT COMPLIANCE
Wood Installations
Metal Installations
Concrete Installations
Backer Plate Installations
User Information
Date of First Use:
Serial #:
Trainer:
User:
OSHA 1910.140 & OSHA 1926.502
YES
YES
YES
YES
ANSI Z359.18 & ANSI A10.32
YES
YES
YES
YES
1