Related Manuals for Aetechron 7548RLY
Summary of Contents for Aetechron 7548RLY
- Page 1 7548RLY / 7796RLY Operator’s Manual Supplement For Variable Very-Low-Impedance Loads in Controlled-Current Mode APPLIES TO UNITS WITH MAINBOARD V4 PART NUMBER 65-8005300-H 574.295.9495 | www.aetechron.com 2507 Warren Street, Elkhart, IN 46516...
-
Page 2: Factory Configuration
7548RLY / 7796RLY OPERATOR’S MANUAL SUPPLEMENT – SECTION 1 NOTE This Supplement only provides information specific to the 7548RLY and 7796RLY models and is in- tended to be used together with the AE Techron 7548/7794/7796/7796HC Operator’s Manual. Please refer to the Operator’s Manual for general... - Page 3 7548RLY / 7796RLY OPERATOR’S MANUAL SUPPLEMENT – SECTION 1 3 Setup, Operation and Main Board Functions: DIP Switch, and Jumper Settings Troubleshooting These configuration settings and locations are Please refer to the 7548/7794/7796/7796HC Op- valid for 7548RLY/7796RLY amplifiers with a Rev erator’s Manual for 7548RLY/7796RLY Setup In-...
- Page 4 7548RLY / 7796RLY OPERATOR’S MANUAL SUPPLEMENT – SECTION 1 DIP switches and jumpers controlling functions CAUTION functions and the factory default settings. Refer to Figure 3.2 for control locations on the amplifier The 7458RLY/7796RLY is designed for pulsed opera- main board. Figure 3.3 details the factory default tion and should not be run at high power levels for long settings for all 7548RLY/7796RLY DIP switches.
-
Page 5: Specifications
7548RLY / 7796RLY OPERATOR’S MANUAL SUPPLEMENT – SECTION 1 4 Accuracy Amplitude vs. Frequency 1V input, 20A output, amplifier transconductance set to 20: Transconductance Load Input Signal 1 kHz 100 Hz 2 ohms Sine 19.9 1 ohm Sine 0.5 ohm...
Need help?
Do you have a question about the 7548RLY and is the answer not in the manual?
Questions and answers