•
Detach the central earth (ground) wire at the en-
gine block.
•
Remove the left air intake pipe at the cylinder
head.
•
Heat the ball joint mount at the leading link to
max. 120 °C (248 °F) and detach it.
e
Caution:
Do not scratch the surface of the leading link.
•
Detach the line for the front brake caliper at the
junction block/frame.
•
Remove the caps from the threaded connections
on the fixed tubes.
•
Separate the fixed tube from the fork bridge at
the threaded connections.
•
Remove the telescopic fork.
•
Remove the cover plate over the upper suspen-
sion strut mount on the frame.
•
Remove suspension strut.
•
Remove the leading link caps.
•
Remove the left screw cap.
•
Remove the circlip at the right and the safety
cap.
•
Take out the screw at the right and pull the shaft
out to the left.
•
Remove the leading link.
•
Detach the hose for the oil cooler at the engine.
•
Remove frame.
•
Install by following the above work instructions in
the reverse order.
11.17