Icom IC-2400A Instruction Manual page 31

RELATED FUNCTIONS 6
6) To cancel the scan, push the [UP] or [DN]
switch on the microphone.
eThe TUNING CONTROL and some other
switches also cancel the scan.
7) To scan the SUB band, push the [SUB] switch
then follow steps from 1 above.
USING SET MODE
BB SETTING SCAN These settings can only be programmed in VFO
EDGES mode.
Scan edges can be set in the MAIN and SUB
bands separately.
1) Push the [VFO/M] switch to select VFO
mode.
2) Push the [SET] switch several times until
The display shows programmed "A" flashes.
scan edge frequency A on the
` MAIN band.
3) Rotate the TUNING CONTROL to set a
. desired scan edge frequency.
eTo select 1 MHz tuning step increments,
push the [MHz] switch. (p. 12)
4) Push the [SET] switch once.
e "b" flashes.
The display shows programmed 5) Rotate the TUNING CONTROL to set the
scan edge frequency B on the
MAIN Gand: other scan edge frequency.
6) Push the [VFO/M] switch to set scan edges
and exit SET mode.
7) To set the SUB band scan edges, push the
[SUB] switch then follow steps from 1
above.