Icom IC-2400A Instruction Manual page 14

—rp
(1) 4 DIFFERENT
MODES
MODE CONSTRUCTION
(2) SET MODE
SELECTION
[SET]
[VFO/M]
[BAND]
The transceiver has 4 different modes for versatile
multi-function operations.
This mode is used for normal operations over the
entire band.
This mode is used for operating the transceiver
using memory channel contents. You can use 20
memory channels for each band. i
This mode provides 1 call channel for each band.
Y ou can program your most often-used frequencies
into these channels.
This mode is used to program data.
1) Push the [BAND] switch to select the operating
band on the MAIN band display.
2) Push the [VFO/M] switch to select VFO or
MEMOR Y mode.
e A different display appears depending on the
selected mode. (p. 11)
3) Push the [SET] switch to select SET mode.
e Refer to the SET mode construction charts.
(p. 11)
4) Push the [SET] switch to advance SET mode.
5) Push the [VFO/M] switch to exit SET mode.
6) To access SET mode in the SUB band, push the
[SUB] switch then follow steps from 2 above.