J2936bk0.book Page 19 Tuesday, September 2, 2003 3:06 PM
Attach the parallel printer cable to the parallel connector on the computer and tighten
3
the two screws. Attach the cable to the connector on the printer and snap the two clips
into the two notches.
Turn on the printer and then turn on the computer. If the Add New Hardware Wizard
4
window appears, click Cancel.
Install the printer driver if necessary. See the documentation that came with your
5
printer.
Connecting a USB Printer
NOTE: You can connect USB devices while the computer is turned on.
Complete the operating system setup if you have not already done so.
1
Install the printer driver if necessary. See the documentation that came with your
2
printer.
parallel connector on computer
screws (2)
parallel printer
cable
notches (2)
connector on printer
clips (2)
Setting Up and Using Your Computer
19