Icom IC-M25 Instruction Manual page 28

9
ATIS CODE
(For only the NLD and FRG versions)
The Automatic Transmitter Identification System (ATIS) ID consists of 10 digits. You can
set and confirm the ID as shown below.
NOTE: You can enter this initial code ONLY ONCE. After entry, only your dealer or
distributor can change it. If your ATIS code has already been entered, this entry is not
necessary.
D Setting the ATIS code
1. Turn OFF the transceiver.
2. While holding down [16/C], push [ ].
• Enters to the ATIS Code Setting mode.
3. Push [▲] or [▼] to select the number for the first digit of
the ATIS code.
4. Push [CH/WX] to select the next digit, and then push [▲]
or [▼] to select a number.
• Pushing [VOL/SQL] selects the previous digit.
5. After the 10th digit has been input, push [Hi/Lo] to store
the code.
• The code number stops blinking.
• Push [16/C] to return to the normal operating mode.
D ATIS code confirmation
( Can be performed only when the ATIS code has been
programmed.)
1. Turn OFF the transceiver.
2. While holding down [16/C], push [ ] to enter the ATIS
Confirmation mode.
• The stored code number is displayed.
• Push [CH/WX] to select the next digit, push [VOL/SQL]
to select the previous digit.
3. Push [16/C] to exit the ATIS Confirmation mode.
19