Simplicity CFC Series Operator's Manual page 39

Adjustments
Neutral
Exact neutral position of transmission control linkage (A,
figure 21) can be adjusted by changing position of linkage on
frame bracket (B). With control levers in neutral position,
wheels should not turn in forward or reverse direction. To
adjust neutral:
1. Block frame up so both drive wheels are off the ground.
2. Place weight in operator's seat to start engine.
3. With control levers in neutral gate, start engine and leave
in fast throttle position. If either wheel turns in forward or
reverse direction, perform steps 4 and 5.
4. Loosen capscrew (C) and nut securing transmission
control linkage (A). Move linkage forward or backwards
until wheel stops moving.
5. Retighten hardware, making sure wheel does not rotate
after hardware is tightened. Repeat steps for opposite
wheel if necessary.
6. Shut engine off and remove weight from seat. Lower
rider to the ground.
Figure 21.
A. Transmission Control Linkage
B. Frame Bracket
C. Capscrew
37