Simplicity CFC Series Operator's Manual page 24

Troubleshooting
CONTENT OF SECTION
This section of the manual provides troubleshooting and
repair instructions for the more common and easily
corrected problems. For other problems, it is recommended
that you contact your dealer.
WARNING
Perform maintenance on the rider or mower only when
the engine is stopped and the parking brake engaged.
Always remove the ignition key before beginning the
maintenance to prevent accidental starting.
Problem
Cause/Remedy
1. Engine will not turnover or start.
A. Clutch pedal not depressed (wheel-steer). Depress pedal. Control levers
not in neutral gate (lever-steer). Place in neutral gate to engage switch.
B. PTC lever not In disengaged position. Pull lever rearward
to disengage.
C. Out of fuel. Allow engine to cool then refill the fuel tank.
D. Engine flooded. Push choke knob in.
E. Circuit breaker is tripped. Wait one minute for automatic
reset. Replace if defective.
F. Battery terminals require cleaning. See Normal Care section.
G.
Battery discharged or dead. Recharge or replace. See
Troubleshooting section.
H. Wiring loose or broken. Visually check wiring & replace broken
or frayed wires. Tighten loose connections.
i. Solenoid or starter motor faulty. Repair or replace.
J. Seat switch faulty. Replace If needed (see your dealer.)
K. Spark plugs faulty, fouled or Incorrectly gapped. Clean and gap
or replace. See engine manual.
L. Stale gas or water in fuel. Drain fuel and refill with fresh fuel.
22