Related Manuals for Orno Guardo OR-VID-MO-1076
Summary of Contents for Orno Guardo OR-VID-MO-1076
- Page 1 Operating and installation instructions Video doorphone set Guardo OR-VID-MO-1076 STOP!
-
Page 2: Table Of Contents
Additional information about ORNO products is available at www.orno.pl. Orno-Logistic Sp. z o.o. holds no responsibility for the results of non-compliance with the provisions of the present Manual Orno Logistic Sp. z o.o. reserves the right to make changes to the Manual - the latest version of the Manual can be downloaded from www.orno.pl Any translation/ interpretation rights and copyright in relation to this Manual are reserved. -
Page 3: Characteristics Of The Set
2. CHARACTERISTICS OF THE SET Videodoorphone is designed for installation in 1-family buildings. Functions: - talking to a person at the entrance and observing at the same time; - direct control of an electric door strike; - 3 access methods: using proximity cards and key tags, by reading a pre-entered fingerprint or by entering a PIN code on the illuminated keypad;... -
Page 4: Outdoor Unit
OUTDOOR UNIT SENSOR TYPE: CMOS RESOLUTION: 1080P FHD VIEWING ANGLE (VERTICAL/HORIZONTAL): 54° / 107° NIGHT LIGHTING: NUMBER OF DIODES: NIGHT VISION RANGE: RFID READER: RFID-tags/cards 13,56 MHz (max. 200 users) MAXIMUM TRANSMITTING POWER: <10mW ERP CODE LOCK: yes, backlit buttons FINGERPRINT READER: MOTION SENSOR: INGRESS PROTECTION:... -
Page 5: Installation
OR-VID-MO-1076KV/S OR-VID-MO-1076KV/F fig. 2 Construction of the outdoor unit OUTDOOR UNIT 1. Camera illumination 7. Fingerprint reader 2. Microphone 8. Loudspeaker 3. Camera lens 9. Camera mode change button: 1080P-720P-CVBS 4. Numeric keypad 10. Door opening time adjustment (1-10sec.) 5. RFID reader field 11. -
Page 6: Outdoor Unit With Camera Installation
OUTDOOR UNIT WITH CAMERA INSTALLATION fig.4 Outdoor unit placement Recommended installation height of the outdoor unit is 140-170cm. The correct location of the outdoor unit determines the comfort of working with the device. It is recommended to test the device before making mounting holes. Do not place the outdoor unit and monitor in the same room as feedback may occur. -
Page 7: Wiring Diagrams
6. WIRING DIAGRAMS Before drilling the installation holes, it is recommended to carry out a functional test of the device. To do this, connect the device for a test according to the wiring diagram. The first person holding the camera should use the button to call the second person who is at the monitor. - Page 8 fig. 8 Wiring diagram It is forbidden to make connections to live equipment! Failure to adhere to this recommendation may result in permanent damage to the device and loss of health.
- Page 9 fig. 9 Wiring diagram The set does not include an electric door strike and automatic gate control unit! The video doorphone cables should not be routed in one cable with the cables of other installations such as bell, alarm, etc. Any power and telecommunication cables emitting strong magnetic fields (e.g. loudspeaker columns, TV set) in direct contact with the cables connecting the outdoor unit to the monitor may adversely affect the operation of the set.
- Page 10 fig. 10 Wiring diagram...
- Page 11 The type of cable and its connection is shown below. The correct operation of the device largely depends on the type of cable used. When designing the electrical installation, it is important to consider the appropriate cross-section of the wires: 1.
-
Page 12: Keypad Programming
7. KEYPAD PROGRAMMING OPERATION Administrator password: used to enter programming mode, factory default 123456. ID No.: sequential number from 000 to 199. ENTER PROGRAMMING MODE Enter the administrator password and confirm using the button # (beeps 2 times and keypad backlight flashes). EXIT PROGRAMMING MODE Press the button ��... -
Page 13: Menu
8. MENU An icon highlighted in red means that motion detection for a particular channel is enabled. Grey indicates that motion detection for a particular channel is disabled. 1: Mode: at home, normal operating status. The call on the outdoor unit will be redirected to the monitor and in the application. -
Page 14: Settings
9. SETTINGS SYSTEM SETTINGS 1. Language: change the language of the system to one of the available options. 2. Device ID: assigning a device ID is an important part of the configuration in the system. For the whole set to function correctly, the device address configuration must be correct. -
Page 15: Desktop
10. DESKTOP WINDOWS 10 ANDROID STANDARD... -
Page 16: Devices
11. DEVICES 1. Enable or disable channel: if the channel is disabled, it will not be possible to monitor or configure its settings. It will not appear in the application. Additionally, you can change the device name (maximum of 9 characters). 2. -
Page 17: Records
13. RECORDS In the records, you will find all recorded conver- sations, voice messages left by visitors, photos/ videos taken during detected motion, and alarm records. Click on a file to play it directly; press and hold a file to access file options. Note: to ensure the proper functioning of this feature, an SD card must be inserted into the monitor. -
Page 18: Monitoring
16. MONITORING Monitor settings. Adjust the brightness, contrast, image saturation, and volume of the monitor. Save the image/video displayed in the preview. Change the monitoring channel (door 1 > door 2 > camera 1 > camera 2). Start/end the call. Open/close the wicket/door. -
Page 19: Mobile App
17. MOBILE APP DOWNLOAD AND INSTALLATION 1. Open the App Store (iOS) or Google Play (Android) on your phone. Search for the “Tuya Smart” app and install it, or scan the QR code on the left. 2. If you do not already have an account in the app, click on Sign Up . -
Page 20: App Usage
18. APP USAGE Important: to ensure the correct functioning of the application, the user is obliged to update the application in accordance with communications from the application operator. Channel change (door 1 > door 2 > camera 1 > camera 2). Mute. -
Page 21: Cleaning And Maintenance
Simplified declaration of conformity Orno-Logistic Sp. z o.o. declares that the type of radio device OR-VID-MO-1076 Video doorphone set Guardo is compliant with the Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following web address: www.orno.pl...
Need help?
Do you have a question about the Guardo OR-VID-MO-1076 and is the answer not in the manual?
Questions and answers