Locating The Switch Settings - NEC VERSA 6000 Series Service Manual

2-16 Setup and Operation
You should only use the BIOS upgrade diskette for the specific model.
1. Check that computer power is off. Turn the NEC Versa 6000 upside down with
the front of the unit facing you.
Remove the hard disk drive.
2.
Locate switch 1 on the four-position dip switch in the hard disk drive bay.
3.
Set the switch to "off" to enable BIOS reprogramming.
4.
Replace the hard disk drive and the compartment cover.
5.
Now you are ready to begin the actual update procedure using the following
steps.
6. Make sure that power is off, and not docked. Insert the BIOS Update diskette
into diskette drive A.
Power on the computer with the diskette in drive A. The computer boots and
7.
automatically loads the utility. A message similar to the following appears:
Press Enter to continue.
8.
Figure 2-13 Locating the Switch Settings
FLASH ROM EQUIPPED
WARNING: The BIOS Update Procedure
is about to begin, press ENTER to continue.
To abort, remove the diskette and reset the unit.