Lcd Status Bar, Versaglide Assembly, Metal Keyboard Support - NEC VERSA 6000 Series Service Manual

4-14 Field Service Guidelines

LCD Status Bar, VersaGlide Assembly, Metal Keyboard Support

Remove the LCD status bar, VersaGlide and/or metal keyboard support as follows.
1. Remove the LCD and top cover as previously described.
Remove the LCD status bar as follows.
2.
Locate the ribbon cable that attaches to the CPU board via connector P5.
Use the tip of a screwdriver and carefully open the connector tabs.
Lift up the LCD status bar.
3. Remove the VersaGlide assembly as follows.
Locate the cable on the VersaGlide assembly.
Disconnect the cable from connector P6 on the CPU board.
Lift the VersaGlide out of the base unit.
4. After removing the LCD status bar and VersaGlide, lift the metal keyboard sup-
port.
Figure 4-11 LCD Status Bar, VersaGlide Assembly, Metal Keyboard Support