Configuring the Switch Settings
Some system settings are set through DIP switches. The six-position dip switch is
located on the bottom of the system. The switch is accessed by removing the memory
module bay cover.
See the following sections for information on accessing the DIP switches and
identifying DIP switch settings.
Accessing the DIP Switch
Follow these steps to access the DIP switch in the memory bay.
Power off the system and disconnect any peripheral devices.
1.
Turn the system over and locate the screw on the memory bay.
2.
Remove the screw and lift off the memory module bay cover. See "Identifying the
3.
Switch Settings" for information about each setting.
Reassemble the NEC Versa components as follows.
4.
!
!
!
Memory module bay cover and screw
A – Screw
Replace the memory module bay cover.
Replace the screw.
Turn the system over.
B –Memory Module Bay Cover
Using the BIOS Setup Utility 3-19