Updating The System Bios - NEC VERSA 6000 Series Service Manual

Switch 2, Password Override Switch — The default setting is "OFF." For exam-
ple, if the customer forgets their password and cannot access data, change the
setting to "ON" and your current password dissolves.
To enter a new password, reset the switch to "OFF," and follow the instructions
listed later in this section under "Setting an Initial Password." You may want to
keep this password in a special place so that you don't forget it again!
Switch 3 — Reserved for factory use.
Switch 4 — Reserved for factory use.

Updating the System BIOS

Use the following steps to update the NEC Versa 6000 system BIOS with the BIOS Update
diskette (BUD). Specifically, the BIOS is the code transmitted onto your system's micro-
processor, or central processing unit (CPU).
If you determine that the default BIOS needs an upgrade, to receive a copy of the BUD
contact the NEC Versa Diskette Fulfillment Center at (800) 842-6446, or NEC Customer
Service and Support (800) 632-4525, Fax (508) 635-4666, or the NEC Bulletin Board
(508) 635-4706.
NOTE: You only need to update the BIOS if
NEC makes significant improvements or fixes to
the current system BIOS.
Setup and Operation 2-15