Post Error Messages - NEC Versa 2200C Series Manual

NOTE
related to display devices, it cannot display on either
the LCD or a CRT. The system warns you with a
beep.

POST Error Messages

The NEC Versa 2200C has a built-in checking program
that automatically tests its components when you turn the
system power on. This diagnostic test is called the Power-
On Self-Test (POST). If the system finds a problem during the
POST, the system displays an error message. If this hap-
pens, follow the instructions in the POST error message
table.
MESSAGE
Diskette drive A
failure
Diskette read failure –
press to run Auto
F1
Setup. Press any other
key to retry boot
Non-system disk or
disk error; replace
and press any key
when ready
5-4 Solving Problems
When the NEC Versa 2200C detects an error
POST Error Messages
WHAT TO DO
Drive A does not work or the diskette is not properly
inserted. Drive A is the diskette drive.
Press to start Auto Setup to check the diskette
F1
drive parameters.
If there's still a problem, drive A might need repair.
Remove the diskette from drive A and press
enter Auto Setup to confirm that the diskette drive is
configured properly or press any other key to start
the system from the hard disk.
Or, insert a bootable disk in drive A and press any
key to start the system from the diskette.
Remove the diskette from drive A and press any
key to start the system from the hard disk.
Or, insert a bootable diskette in drive A and press
any key.
to
F1