NEC Versa 2200C Series Manual page 63

MESSAGE
No boot device
available – press
F1
to run Auto Setup
Invalid configuration
information – run
Setup program
Real time clock
failure
Time-of-day not set –
run Setup program
Fixed disk
configuration error
Fixed disk failure
POST Error Messages
WHAT TO DO
Press to start Auto Setup. Change the hard
F1
disk type to the correct setting. Exit and save
Auto Setup.
Or, check to see that the hard disk is properly
installed.
One or more system configuration parameters
are not properly set. Press
set them correctly, exit, and save to update
the parameters.
Set time and date using Auto Setup. Exit and save
to update the parameters.
Set the time and date using Auto Setup. Exit and
save to update the parameters.
Start Auto Setup. Exit and save to update the
parameters. Turn off the system and check to see if
the hard disk is inserted properly.
Insert a bootable diskette in drive A and press
to start the system from diskette.
Ctrl+Alt+Del
If the system only boots from diskette, the hard disk
might need repair.
Press F1 to start Auto Setup. Exit and save to
update the parameters.
Turn off the system and check to see if the hard
disk is inserted properly.
If the system only boots from diskette, the hard disk
might need repair.
to start Auto Setup,
F1
Solving Problems 5-5