Using Auto Setup - NEC Versa 2200C Series Manual

Using Auto Setup

Use Auto Setup as follows:
1. Reboot your system. When the screen displays the
blinking block at boot-up, press
2. When the Auto Setup Summary screen is displayed, en-
ter the highlighted letter in the menu bar that represents
the category you want.
For example, type
window.
Use the up and down arrows to move between selections
3.
displayed on the screen. Press
display setting options.
Follow the instructions at the bottom of the screen to
4.
make selections, change values, and exit.
NOTE
enter. If you set a system password, a key icon ap-
pears at bootup. You must enter the password to
access the system. To change the password, enter
the password followed by a forward slash (/) and a
new password. To remove the password, enter the
password followed by a forward slash (/).
Refer to the online Advanced Topics for details on Auto
Setup.
3-8 About the Software
to open the Disk Drive Settings
D
Be sure to keep track of any password you
.
F1
+ the arrow keys to
Alt