170 Series - NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual

NOTE
NOTE
Table 4-4 170 Series Software
SVP Server Installation, Setup, & Maintenance Manual - Revision 1
Enter Netlink when using the 160 series software and a Telephony
Step 1
Gateway.
Select the link speed or select auto-negotiate to permit the SVP
Step 2
Server to auto-negotiate in the Ethernet link field.
Enter a Y (Yes) or N (No) in the System Locked field. This option is
Step 3
used to take the system down for maintenance. The default entry is N
(No). Set it at Y (Yes) to prevent any new calls from starting. Return to N
to restore normal operation.
Maintenance Lock prevents any new calls from starting and is set
Step 4
automatically by the system to Y (Yes) after certain maintenance
activities that require reset.If an IP address is changed, the system must
be reset, so a Y displays in the Maintenance Lock field.
(Optional) Select the Reset System option if you want to be prompted to
Step 5
reset the SVP Server upon exiting this window. Note that resetting the
SVP Server will terminate any calls in progress.
The administrator cannot change the Maintenance Lock option. It is automatically set
by the system. Reset the system at exit to clear aintenance Lock.
The SVP Server should be reset at the end of any maintenance procedure that requires
a reset either by the Maintenance Lock option or manually by selecting the Reset
System option.

170 Series

The 170 series software is required in NEC IP environment. Ensure the
latest version is installed on the SVP Server. Check the version
currently installed on the SVP Server as described in
Name Major Version number
Table of Contents 173
Functional Code 174
File System 175
When Netlink IP is selected as the SVP-II Mode, the 170 Series version
will display the options shown in
Configuring the SVP Server
Chapter 7.
Filename
svp100.toc
zvmlinux
flashfs
Figure 4-5.
4-9