Send All; Svp Server Configuration - NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual

4-6 Configuring the SVP Server
NOTE

SVP Server Configuration

Send All

In an IP system with multiple SVP Servers, the SendAll option is
provided to speed configuration and ensure identical settings.
The S=SendAll option allows you to send that configuration parameter
to every SVP Server on the LAN. SendAll can only be used after the
IP address is established on EACH SVP Server via the serial connection.
If you anticipate identical settings across the LAN, set just the IP
address and custom hostname (if desired) for each SVP Server using
the initial serial connection. Then connect via the LAN and use SendAll
to set identical configuration options for all SVP Servers.
If SendAll is to be utilized in your system, all passwords must be
identical. DO NOT CHANGE THE PASSWORD AT THE INITIAL
CONFIGURATION IF THE SEND ALL OPTION IS DESIRED. Use the
default password and change it globally if desired after a LAN connection
is established for all SVP Servers.
If independent administration of each SVP Server is desired, the
passwords may be set at initial configuration.
To change the IP address of the master SVP Server, change it in this menu and
reboot the system. Then you may change alias IP addresses in each of the other
SVP Servers without error.
The type of gateway you are using determines the mode of the SVP
Server. Select from either the 'Netlink' or 'Netlink IP' to interface
with the Telephony Gateway or IP Telephony Server respectively. The
SVP-II Configuration
Server is set. It is also the menu used to lock the SVP Server
for maintenance and reset the Server after maintenance.
The SVP Server automatically locks for maintenance if the IP address
is changed. When this Maintenance Lock occurs, the SVP Server must
be reset upon exit. All active calls are terminated during a reset.
The SVP Server window also displays options for the Telephony
Gateway system configuration. Use the following steps to complete the
Configuration window.
Select SVP-II Configuration on the System menu
Step 1
4-2) and press ENTER. The SVP-II Configuration window displays
(Figure 4-3).
SVP Server Installation, Setup, & Maintenance Manual - Revision 1
window(Figure 4-3) is where the mode of SVP
(Figure 4-1 on page