Installing The Svp Server; Customer Required Material; Locate The Svp Server - NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual

3

Installing the SVP Server

Chapter Topics

Customer Required Material

Table 3-1

Locate the SVP Server

SVP Server Installation, Setup, & Maintenance Manual - Revision 1
As shown in the system diagram
Server is connected to the Ethernet switch. This chapter describes
specifications which allow flexibility in physical placement of the
components within stated guidelines.
• Customer Required Material
• Locate the SVP Server
• Mounting and Connecting the SVP Server
Table 3-1 lists equipment that must be provided by the customer.
Customer Requirements for SVP Server
Equipment
Power Outlet
Backboard space
Screws
CAT 5 Cable
The SVP Server measures approximately 4 x 12.5 x 7 inches, and
weighs about five pounds. The unit is designed to be wall mounted,
vertically or horizontally, over ¾" plywood.
(Figure 2-1 on page
Requirements
The outlet must accept the AC adapter provided by NEC Business
Solutions Ltd.
¾" Plywood secured on the wall
The SVP Server is designed to be wall mounted to
Note:
¾" plywood securely screwed to the wall.
Required to mount the SVP Server to the wall. Four #8 -
¾" panhead wood screws (or similar device) are required.
A RJ-45 connector is needed at the SVP Server to connect
to the Ethernet switch.
3-1
2-5), the SVP