Configuring The Svp Server; Connecting To The Svp Server; Connecting Via The Serial Port - NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual

4

Configuring the SVP Server

Chapter Topics

Connecting to the SVP Server

SVP Server Installation, Setup, & Maintenance Manual - Revision 1
This chapter describes the initial setup of the SVP Server, including
how the IP address is set and how to determine the number of active
calls per access point. It also discusses the option of entering a
hostname and a location for software updates via TFTP.
• Connecting to the SVP Server
• The System Menu
• Network Configuration
• SVP Server Configuration
• IP System Configuration
• Change Password
The initial connection to the SVP Server must be made via a serial
connection to establish the SVP Server's IP address. After the IP
address is established, connection to the SVP Server may be done
via the network using Telnet. It is recommended that the basic setup
actions are completed while the serial connection is being made.

Connecting via the Serial Port

Use the following steps to connect through the serial port.
Using a DB-9 female, null modem cable, connect the SVP Server
Step 1
to the serial port of a terminal or PC.
4-1