BWT AQA drink OFFICE Installation And Use Manual page 4

BUILDER'S
this term is used to identify the manufacturer of the tap, with his name on
GLOSSARY:
the EC Declaration of Conformity
the term device or drinking fountain is used to identify the water
DEVICE: EXPOSED
dispenser. any person standing near the device
PERSON: RESIDUAL
This term is used to identify all dangers that are not obvious and cannot
RISKS:
be eliminated at the design stage of the machine, as appropriate
countermeasures would compromise the operation of the machine,
GENERAL AND SAFETY WARNINGS
WARNING: Read the instruction manual carefully and store it in a dry, protected place; keep
it close to the appliance so that it can be consulted if necessary.
◼ Do not leave the packaging material (box, bag, staples, etc.) within the reach of children. It
is advisable to keep the packaging for future re-use; otherwise dispose of the materials in
accordance with the regulations in force.
If the appliance has been dropped or has visible defects or malfunctions, do not use it and
◼
do not attempt to dismantle or tamper with it. You should contact your dealer directly for
repair.
◼ Store the device on a stable surface; the place must not be exposed to the weather
(sun, rain, frost, etc.).
◼ Do not place the appliance on top of other electrical appliances.
Place the device away from heat sources.
◼
◼ Installation, maintenance not covered in this user manual and repairs must only be carried
out by qualified and specialised personnel authorised by the manufacturer; always contact
your dealer or service centre.
◼ Do not place the device on top of other devices.
◼ Place the device away from heat sources.
◼ Installation, extraordinary maintenance and repairs may only and exclusively be carried out by qualified and specialised
personnel authorised by the manufacturer; always contact your authorised BWT ITALIA S.r.l. dealer or service centre.
◼ The water supply to the appliance must be exclusively potable water.
◼ If the power cable is damaged, it must be replaced by the dealer or his service department in order to prevent any risk.
◼ Do not crush the electric cable or place heavy objects on it.
◼ Do not use adapters to connect the device to the electrical outlet.
Do not pull the plug from the power socket with wet or damp hands.
◼
◼ Do not pull the power cable or the appliance to unplug it from the power socket.
Do not leave the unit running unattended and keep it out of the reach of children.
◼
◼ In the event of faults (water l e a k a g e or other), disconnect the power s u p p l y and close the water inlet valve.
◼ Do not use the device in explosive environments.
◼ The appliance must always remain electrically powered.
◼ Do not climb or sit on the device.
◼ Use only original accessories.
◼ Absolutely do not immerse the device in water.
For hygienic reasons, do not touch the water spout.
◼
◼ If the appliance has been switched off for more than 24 hours, dispense at least 5 litres of water before consumption.
If no water has been dispensed for more than 24 hours, dispense at least about 2 litres of water before consumption.
◼
◼ Do not clean the device with water jets.
Carry out all cleaning or maintenance operations with the appliance switched off, without water supply and with the electrical
◼
plug disconnected from the 230V 50Hz socket.
◼ When the equipment is taken out of use for scrapping, it must be rendered unusable.
◼ The dispenser must be used in full compliance with hygiene regulations to ensure the quality of the dispensed product.
◼ In the event of improper use, non-compliance with the operating instructions, or tampering with the appliance, the manufacturer
is not liable for any damage caused to persons, animals or property.
The manufacturer disclaims all liability in the specific cases set out below:
◼ improper use of the device;
◼ use contrary to specific national regulations (power supply, installation and maintenance);
◼ installation performed by unauthorised personnel;
power supply faults (electrical discharges - power surges - water mains overpressure - low water pressure);
◼
◼ unsuitable operating environment temperature;
deficiencies in planned maintenance;
◼
◼ unauthorised modifications or interventions;
use of non-original or non-model-specific spare parts;
◼
◼ total or partial disregard of instructions.
4 I N S T A L L A T I O N A N D U S E - A Q A D R I N K O F F I C E
AQA Drink OFFICE