BWT AQA drink OFFICE Installation And Use Manual page 10

CLEANING AND SANITISING
The following table is a guide to the scheduled cleaning and sanitising operations that should be carried out on the appliance
according to the suggested periodicity.
PART OF THE APPLIANCE TYPE OF INTERVENTION
Weekly Monthly Quarterly
✓
front and bodywork
cleaning
✓
hydraulic circuit
sanitisation
✓
Total luminaire
sanitising/cleaning
The times given in the table above refer to normal conditions of use. In any case, refer to local health regulations. T h e frequency of
intervention is directly proportional to the heaviness o f use of the machine.
EXTERNAL CLEANING
Careful cleaning must be followed to maintain the machine in good condition. General cleaning of the machine must be carried out
with the machine switched off, using neutral detergent products diluted in water and a damp cloth. Do not use products containing
solvents or alcohol. It is forbidden to wet electrical connections, switches, buttons etc. with water. The slits on the chassis at the
rear of the machine can be cleaned with the help of a dry brush.
TOTAL SANITISATION OF THE APPLIANCE
It is good practice (essential in risky conditions) to sanitise the appliance completely every 3 months to avoid possible bacterial
contamination of the appliance. For this, we recommend that you request the intervention of a qualified technician equipped for
this purpose from your dealer or authorised service centre or, alternatively, use the Point-of-Use (POU) sanitising kit available from
BWT dealers (not included in the scope of delivery code 31863AA)
PERIODIC SANITISATION OF THE HYDRAULIC CIRCUIT
If the appliance has not been used for a long period of time (switched off for one or more weeks e.g. holiday period) or when
replacing the BWT Bewapur filter cartridge, it is obligatory to carry out periodic sanitisation when switching back on, following the
procedures in the appliance sanitisation kits at the point of use.
LOWER TECHNICAL COMPARTMENT
The technical compartment that can b e opened from the front of the unit allows the CO2 cylinder with a capacity of up to 4000g
and the removable drip tray to be housed inside.
Photo of lower technical compartment with open door
The drip tray is connected to the tray under the dispenser and avoids having to connect the machine to a drain. Its capacity is
approximately 2 litres. When full, the two sensors signal the machine's control unit that it needs to be emptied.
When the canister is emptied manually, after being removed from its seat and reinserted, the machine resumes its regular keyboard
operation. (self-resetting)
10 I N S T A L L A T I O N A N D U S E - A Q A D R I N K O F F I C E