Mounting The Device; Mounting On A Wall; Mounting On A Horizontal Surface - SMC Networks WBR14S-3GN User Manual

M D
OUNTING THE EVICE
M W
OUNTING ON A ALL
M
OUNTING ON A
H S
ORIZONTAL URFACE
C
The wireless 3G Broadband Router can be mounted on any horizontal
surface, or on a wall. The following sections describe the mounting options.
The wireless 3G Broadband Router should be mounted only to a wall or
wood surface that is at least 1/2-inch plywood or its equivalent. To mount
the unit on a wall, always use its wall-mounting slots.
To mount on a wall, follow the instructions below.
Mark the position of the two screw holes on the wall. For concrete or
1.
brick walls, you will need to drill holes and insert wall plugs for the
screws.
Insert two 20-mm M4 tap screws (not included) into the holes, leaving
2.
about 2~3 mm (0.08~0.12 inches) clearance from the wall.
Line up the two mounting points on the unit with the screws in the wall,
3.
then slide the unit down onto the screws until it is in a secured position.
To keep the wireless 3G Broadband Router from sliding on the surface, the
unit has four rubber feet on its base.
It is recommended to select an uncluttered area on a sturdy surface, such
as a desktop or table. The unit can also be protected by securing all
attached cables to a table leg or other nearby fixed structure.
– 21 –
| Installing the wireless 3G Broadband Router
2
HAPTER

Mounting the Device