Connecting The Power Adapter; Wall Mounting - SMC Networks SMC Barricade g SMC7904WBRA2 User Manual

Connecting the Power Adapter

Plug the power adapter into the power socket on the rear of the Barricade,
and the other end into a power outlet. Check the power indicator on the
front panel is lit. If the power indicator is not lit, refer to
"Troubleshooting" on page A-1.
In case of a power input failure, the Barricade will automatically restart and
begin to operate once the input power is restored.

Wall Mounting

There are 2 slots on the underside of the Barricade that can be used for
wall mounting. The distance between the 2 slots is 120 mm.
You will need 2 suitable screws, the diameter would be 4.4 mm, to wall
mount the Barricade.
To wall mount the unit:
1. Determine where you want to mount the Barricade.
2. Drill two holes into the wall. Make sure the holes are 120 mm apart.
3. Insert a screw into each hole, and leave 5 mm of its head exposed.
4. Maneuver the Barricade so the wall-mount slots line up with the two
screws.
5. Place the wall-mount slots over the screws and slide the Barricade
down until the screws fit snugly into the wall-mount slots.
Note: When wall mounting the unit, ensure that it is within reach of the
power outlet.
C S
ONNECT THE YSTEM
2-7