Configuring Port Limit Controls; Figure 25: Snmpv3 Access Configuration - SMC Networks SMCGS10P-SMART Management Manual

◆
W
To configure SNMPv3 group access rights:
1.
2.
3.
4.

Figure 25: SNMPv3 Access Configuration

Use the Port Security Limit Control Configuration page to limit the number
C P
ONFIGURING ORT
of users accessing a given port. A user is identified by a MAC address and
L C
IMIT ONTROLS
VLAN ID. If Limit Control is enabled on a port, the maximum number of
users on the port is restricted to the specified limit. If this number is
exceeded, the switch makes the specified response.
P
Configuration, Security, Network, Limit Control
P
The following parameters are displayed on the Port Limit Control
Configuration page:
System Configuration
◆
◆
Write View Name - The configured view for write access.
(Range: 1-32 characters, ASCII characters 33-126 only)
I
EB NTERFACE
Click Configuration, Security, Switch, SNMP, Access.
Click Add New Access to create a new entry.
Specify the group name, security settings, read view, and write view.
Click Save.
ATH
ARAMETERS
Mode – Enables or disables Limit Control is globally on the switch. If
globally disabled, other modules may still use the underlying
functionality, but limit checks and corresponding actions are disabled.
Aging Enabled – If enabled, secured MAC addresses are subject to
aging as discussed under Aging Period.
With aging enabled, a timer is started once the end-host gets secured.
When the timer expires, the switch starts looking for frames from the
end-host, and if such frames are not seen within the next Aging Period,
the end-host is assumed to be disconnected, and the corresponding
resources are freed on the switch.
– 75 –
| Configuring the Switch
C 4
HAPTER
Configuring Security