Advertisement
Quick Links
Advertisement
Related Manuals for HIKVISION DS-K1T804A
Summary of Contents for HIKVISION DS-K1T804A
- Page 1 How to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand...
- Page 2 DS-K1108MK How to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand Introduction: This article will introduce how to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand. 1. Wiring 1) Fingerprint terminal and card reader wiring: Use the wiegand interface to connect these two device.
- Page 3 How to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand 3) Network: Connect the fingerprint terminal, card reader, as well as the computer for configuration to switch. Note: must connect GND/W0/W1. 4) Dip Switch: set the dip switch of card reader to 0000 0100 that mean enable wiegand protocol.
- Page 4 How to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand Check the 804A wiegand communicaiton direction and authentication mode.
- Page 5 How to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand 4) Create a person ,enroll a fingerprint and a card number for test person. 5) Apply the test person to 804A device.
- Page 6 How to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand 6) Check the data applying status, make sure the data have apply successfully. Test it , view the real event form event center, make sure the device have been arming for this 4200. if...
- Page 7 How to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand...
- Page 8 How to use DS-K1T804A Fingerprint Terminal connect to card reader by Wiegand...
Need help?
Do you have a question about the DS-K1T804A and is the answer not in the manual?
Questions and answers