Page 3
SBT2000S (2023) Swing Barrier Turnstile User Manual relating to the use of the information contained in or referenced by this manual, even if ZKTeco has been advised of the possibility of such damages. This manual and the information contained therein may include technical, other inaccuracies or typographical errors.
Page 4
User Manual About the Company ZKTeco is one of the world’s largest manufacturer of RFID and Biometric (Fingerprint, Facial, Finger-vein) readers. Product offerings include Access Control readers and panels, Near & Far-range Facial Recognition Cameras, Elevator/floor access controllers, Turnstiles, License Plate Recognition (LPR) gate controllers and Consumer products including battery-operated fingerprint and face-reader Door Locks.
User Manual Overview The SBT2000S (2023) swing barrier turnstile is designed for smooth and silent operation, drawing very little power. It is made of SPCC, it is highly durable. These barriers are normally held in a locked position, denying access to the secured side. When SBT2000S (2023) reader positively recognizes a user’s valid access card, its barriers swing automatically, allowing users passage to the secured side.
SBT2000S (2023) Swing Barrier Turnstile User Manual 1.2.2 System Components The following figure displays the system components of the SBT2000S (2023): 2. Card Verification Area 1. Traffic Indicator 4. Swig Arm 3. Motor Driver Kit 6. Turnstile Control Board 5. Power Supply 8.
Page 24
0 to 50 and the default value is 12. Master/Slave Setting (09EXXX) Setting up the gate as a master or a slave, the SBT2000S (2023) is an independent system, there is no multi-lane management system, so there is no master-slave relationship.
Page 25
(13E004) Slave position Adjust the position only when SBT2000S (2023) series is installed properly. When setting the zero position, you can manually push the swing arm for fine-tuning. If the barrier exceeds a certain angle, it will be invalid.
Need help?
Do you have a question about the SBT2000S and is the answer not in the manual?
Questions and answers