Emptying The Water Tank - HOMCOM 821-040V90 Instruction Manual

Auto defrost function
When the ambient temperature ≤22℃, the whole machine enters the auto defrost program,
and the corresponding mode indicator flashes during defrosting, compressor stop working
while defrost.
DRAINAGE:

EMPTYING THE WATER TANK

● When the tank is full, The unit will make a buzzing sound, screen will show "FL" and the
Water Full light will turn on.
● Press the POWER button to turn off the unit.
● Pull on the water tank and simply slide out of the body of the dehumidifier.
●Empty the water into an area with a drain or outside.
●Clean the inside of the tank as well as the outside.
●Replace the empty tank back into the unit.
●Press the POWER button to resume operating.
●If the Water Full light does not extinguish, check that the float is correctly in place.
Warning
1. Do not discard water tank magnets and plastic rivets. Otherwise, the machine will not
automatically stop working when the water tank is full, and the condensed water will
overflow and damage the floor of the room.
2. Please be sure to clean the condensed water in the water tank before resetting the
working mode of the machine.
3. If the water tank is dirty, rinse it with clean water. Avoid using detergents, steel balls,
chemical dust removers, diesel oil, benzene, diluents or other solvents. Otherwise, the
water tank will be damaged and leak
4. Replace the empty tank back into the unit. Otherwise, the water full indicator may
remain red and the machine cannot restart.
11