Switching On Amy 2 Modes Io; Wall Mounting - SOMFY Amy 2 Modes io Instructions Manual

EN

2.4.Switching on Amy 2 Modes io

1] To activate the front panel buttons, long press the On/Off button until the
settings feedback LED lights up green. It switches from Off status to On
status.
2] To deactivate the front panel buttons, long press the On/Off button until the
settings feedback LED lights up red: this indicates the Off status.
NOTICE
The PROG button, the Mode button and the channel selector buttons are always active, even when the front panel
buttons are deactivated by the On/Off button.

2.5.Wall mounting

NOTICE
• The use of radio appliances operating on the same frequency may cause interference and reduce the product's
performance.
• Never use the control point near a metal frame or metal surfaces, as this can reduce the radio range.
• The environment in which the product is used might reduce the radio range.
• The use in the same floor as the controlled products is recommended.
• Radio range in free field: 150 m.
There are two possible ways of wall-mounting Amy 2 Modes io, depending on the type of back cover:
▪ By fixing it with double-sided tape (provided with the product).
▪ By fixing it with screws (on the wall or in a flush-mounted box).
2.5.1.Wall mounting with mounting plate and square frame
2.5.1.1. Using double-sided tape
NOTICE
The product is designed to be fixed to most wall surfaces, such as paint, wallpaper, earthenware, wood, varnished
wood, primer/coating. However the walls must be flat and clean.
8
1]
2]
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
Amy 2 Modes io
>2 s
>2 s