Up And Down Buttons - SOMFY Amy 2 Modes io Instructions Manual

EN
NOTICE
To use the Up, Stop/my or Down buttons, they must be activated: the product must be switched on (refer to
Switching on Amy 2 Modes io).

3.1.Up and Down buttons

NOTICE
The use of these buttons depends on the type of motorised products associated with the same channel and the
control mode selected for this channel (refer to Mode selection).
NOTICE
• To make a long press (specific ergonomics of motorised products in mode 2, 3 or 4), only one channel must be
selected at a time. Otherwise, to make a brief press, channels can be selected simultaneously or separately to
operate several products at the same time (refer to Channel selection).
• If no new channel is selected before sending an order, the last selection of channel(s) is used.
• If several channels are selected, orders are sent in sequence as indicated by the LEDs on the channel selector
buttons.
With mode 1 selected
Briefly press one or two buttons of the channel selector to select the motorised
products to be controlled: the green LED of each selected channel lights up.
▪ Press the Up or Down button to raise or lower roller shutters, awnings, or
screens.
With mode 2 selected
Briefly press one or two buttons of the channel selector to select the motorised
products to be controlled: the green LED of each selected channel lights up.
▪ Briefly press the Up or Down button to switch on switch off the lighting or
heating.
▪ Press and hold the Up or Down button to increase / decrease progressively
the lighting or heating.
With mode 3 selected (Exterior Venetian Blinds)
Briefly press one or two buttons of the channel selector to select the motorised
products to be controlled: the green LED of each selected channel lights up.
12
< 0.5 s
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
Amy 2 Modes io
< 0.5 s
> 0.5 s
> 0.5 s