Tips And Advice On Installation; Use And Maintenance - SOMFY Amy 2 Modes io Instructions Manual

Amy 2 Modes io
1] Take the circular back cover and clip the Amy 2 Modes io module onto it,
following the orientation indicated inside the circular back cover. Press firmly
on the front of the module, on the right and left near the my button as close
as possible to the translucent circle without pressing on the edges of the
module (to avoid unwanted radio transmission), until it clicks into place.
2] Amy 2 Modes io can therefore be used as a remote control that can be put
down and moved around.

2.7.Tips and advice on installation

2.7.1.Questions about the product?
Observations
The selected motorised product does not react
at all when a button on Amy 2 Modes io is
pressed (No LED reaction when pressing the
buttons).
The selected motorised product does not react
at all when a button on Amy 2 Modes io is
pressed (No LED reaction in the front when
pressing a button AND in the back when pressing
the On/Off button).
The selected motorised product does not react
at all when a button on Amy 2 Modes io is
pressed but the LED lights up.
The selected motorised product does not react
at all when a button on Amy 2 Modes io is
pressed but the LED lights up and the control
point is paired with this motorised product.
Only one button of the channel selector can be
selected.
The selected motorised product does not react
as it should.
All the LEDs of the channel selection buttons
flash rapidly (6 times).

3.USE AND MAINTENANCE

CAUTION
To prevent damage to the product:
• Avoid impacts!
• Do not drop it!
• Do not spill liquid on the product or immerse it in liquid.
• Do not use abrasive products or solvents to clean the product.
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
Amy 2 Modes io is switched off, the
front panel buttons (Up, Stop/my,
Down) are deactivated.
The control point battery is low.
The control point is not paired with
this motorised product.
External radio equipment is
interfering with the radio reception.
Amy 2 Modes io is switched off, the
channel selector is active but only
one channel can be selected at a
time.
The selected mode does not match
the type of motorised product.
The ergonomics used on Amy 2
Modes io are only possible by
selecting only one channel.
No channel is selected.
Solutions
Switch it on to activate the buttons
(refer to Switching on Amy 2
Modes io).
Change control point battery as
required (refer to Replacing the
battery).
Refer to Adding/Deleting Amy 2
Modes io
Turn off any nearby radio
equipment.
Refer to Channel selection.
Refer to Mode selection.
Select one channel at a time and
repeat the procedure to carry out
the order on all the channels.
Select at least one channel before
sending an order.
EN
11