ekwb EK-FC2080 + Ti Classic Installation Manual page 5

STEP 3
CLEANING THE PCB
Carefully detach the original stock cooler after removing all screws securing
it to the board. Wipe off the remains (by using non–abrasive cloth or q-tip,
as shown on sample photo) of the original thermal compound until the
components and circuit board are completely clean. EKWB recommends
the use of denatured alcohol for removing TIM leftovers.
STEP 3
STEP 4
APPLYING THERMAL COMPOUND
Wipe off the remains (by using non–abrasive cloth or q-tip) of the original
thermal compound until the components and circuit board are completely
clean. Apply thermal compound: lightly coat NVIDIA GPU chip with
enclosed EK-TIM Ectotherm thermal grease. EKWB recommends to apply
thermal grease in cross form for best performance (see sample picture).
STEP 4
- 5 -