ekwb EK-Classic Pump Reservoir 160 SPC PWM D-RGB Installation And Mounting Manuals
Pump-reservoir combo
Hide thumbs
Also See for EK-Classic Pump Reservoir 160 SPC PWM D-RGB:
- Installation and mounting manual (8 pages)
Related Manuals for ekwb EK-Classic Pump Reservoir 160 SPC PWM D-RGB
Summary of Contents for ekwb EK-Classic Pump Reservoir 160 SPC PWM D-RGB
- Page 1 EK-Classic Pump Reservoir 160/260 SPC PWM D-RGB PUMP-RESERVOIR COMBO INSTALLATION AND MOUNTING MANUAL 2nd Revision, June 24th 2020...
- Page 2 The following instructions are subject to change without notice. Please visit our website at www.ekwb.com for updates. Before the installation of this product, please read important notice, disclosure, and warranty conditions printed on the back of the box.
-
Page 3: Table Of Contents
TABLE OF CONTENTS INSTALLING THE ASSEMBLY USING THE ENCLOSED BRACKET (Bracket - XRES Classic Spider) OPTION 1 INSTALLING THE ASSEMBLY OPTION 2 ATTACHING THE FITTINGS CONNECTING THE D-RGB LED STRIP SUPPORT AND SERVICE SOCIAL MEDIA - 3 -... -
Page 4: Installing The Assembly Using The Enclosed Bracket (Bracket - Xres Classic Spider)
INSTALLING THE ASSEMBLY USING THE ENCLOSED BRACKET (Bracket - XRES Classic Spider) OPTION 1 Bracket – XRES Classic Spider assembly M4 × 4mm screw If you have the option to mount the assembly on a 120mm fan or 120mm fan mounting holes, EK recommends the enclosed spider mount - Bracket –... -
Page 5: Installing The Assembly
INSTALLING THE ASSEMBLY OPTION 2 The assembly can be mounted on any flat surface inside your computer chassis. You should drill four (4) 4.2mm holes using a power drill in a 50x50mm square pattern. Please follow these steps: 1. Screw on Vibration Dampers on Custom SPC Screws; 2. -
Page 6: Attaching The Fittings
ATTACHING THE FITTINGS EK-Classic Pump Reservoir 160/260 SPC PWM D-RGB series combo units feature two (2) G1/4 threaded openings on the main body - the INLET and OUTLET, with the first marked ‘IN’ and the latter marked ‘OUT.’ EK recommends using EK-ACF fittings with the EK-XRES SPC series reservoir-pump combo units. -
Page 7: Connecting The D-Rgb Led Strip
CONNECTING THE D-RGB LED STRIP STEP 1 Plug the 3-pin D-RGB connector from your GPU Water Block into a D-RGB header on your motherboard or controller. The LED Strip will only work if the pin layout on the header is as follows: +5V, Data, Empty, Ground. -
Page 8: Support And Service
SUPPORT AND SERVICE In case you need assistance, please contact: http://support.ekwb.com/ EKWB d.o.o. Pod lipami 18 1218 Komenda Slovenia – EU SOCIAL MEDIA EKWaterBlocks @EKWaterBlocks ekwaterblocks EKWBofficial ekwaterblocks...
Need help?
Do you have a question about the EK-Classic Pump Reservoir 160 SPC PWM D-RGB and is the answer not in the manual?
Questions and answers