CyClone RT2E Modern 250 User Manual page 36

Checking and replacing engine oil
Replace the oil after warming up for a few minutes. Please change the oil strictly according to the standards.
1
2
1. Take out the oil dipstick and check whether the oil is black or
deteriorated. Check whether the oil level is below the lower limit. If so,
add oil to the level between the
deteriorated, replace the oil.
2. Place an oil pan under the engine; remove the oil drain bolt and drain
the oil. Oil; turn the engine several times to let the remaining oil flow
out completely, then install the
standard. Drain bolt torque: 15 N·m.
1. Lubricating oil should be replaced when the engine is hot.
2.Do not remove the oil drain bolt when the engine is at high temperature to avoid screw
slippage.
3. When replacing new lubricating oil, it must be filtered.
4. Pay attention to whether the filter, gasket, spring, O-ring and drain bolt are in good
condition. If they are damaged, replace them.
Maintenance
upper and lower limits. If blackened or
drain bolt and add oil according to the
Notice
!
. 35 .