CyClone RT2E Modern 250 User Manual page 32

Operation Guide
New car operation
After purchasing a new motorcycle, users should pay attention to the running-in of the new motorcycle (the first 1000km is the running-in period, and the odometer
reading shall prevail). The running-in of a new motorcycle directly affects the service life of the motorcycle, so users should control the speed within 6500r/min (the
speed shall not exceed 50km/h, as determined by the speedometer) within the first 1000km. After the running-in period, the initial maintenance should be carried
out to compensate for the initial slight wear, extend the service life of the engine, and ensure the best performance of the motorcycle. The company's special engine
oil should be replaced every 300km. If any engine failure occurs during the trial operation during the running-in period, please contact the local dealer or the
company's authorized maintenance service center.
1. 0km〜150km:
When driving, the speed should be controlled at about 4000r/min, the refueling handle stroke should be
controlled within 1/4, and the engine should be cooled for (5-10) minutes after every 1 hour of driving.
2. 150km~500km:
When driving, the speed should be controlled at about 5000r/min, the refueling handle should be controlled
within 1/2 stroke, and the engine should be cooled for (5-10) minutes after every 1 hour of driving.
3. 500km-1000km:
When driving, the speed should be controlled at around 6000r/min and the refueling handle stroke should be
controlled within 3/4.
. 31 .