CyClone RT2E Modern 250 User Manual page 15

User Manual
Instrument indication
1 2 3
10
6 7 8 9
1.When the speedometer indicates that the speed exceeds the red zone (the
driving speed should be controlled outside the red zone as much as possible),
the driver should pay attention to the road conditions to avoid falling off the
vehicle.
2.It is forbidden to drive at high speed for a long time (the speedometer
indication should be controlled outside the red area),
easily cause damage to the motorcycle engine.
It lights up when the engine is stopped or the oil is insufficient
15. Oil pressure warning
during operation.
light
When it is enough, extinguish it.
16. High beam indicator When using high beam, the high beam indicator
. 14 .
4 5
11 14
12 13 15 16
! Danger
otherwise it will
"Bright
name
When the left turn signal is on,
1.Left turn indicator
When the ignition system circuit is turned on, the normal
working condition
2. EFI fault indicator light engine is started, it works normally If there is a fault, the light
will stay on.
The ABS fault light comes on when starting and goes off above
3.ABS fault light
8km/h.
When the battery voltage is less than 12V±0.2V and greater
4.Battery voltage than 15.5V±0.2V, the battery
red light will remain on) will sound an alarm.
When the right turn signal is on,
5.Right turn indicator
When the vehicle is powered on, TCS ON is always on. When the
vehicle speed reaches 8km/h, TCS ON goes out.
6.TCS on indicator light
When the vehicle is powered on and TCS is turned off, the TCS off
7.TCS off indicator light
light is always
When the vehicle speed is greater than 15km/h, blind spot
monitoring and lane change the auxiliary function is activated and
an alarm sounds when there is a vehicle behind you on the left.
8. Left blind spot monitoring
Indicates the amount of fuel in the fuel tank.
9. Fuel gauge
When the yellow light comes on, add fuel immediately.
The mileage reading generated by the motorcycle while driving.
Maximum Displayed as 999999
10. Odometer
Displays the motorcycle engine speed.
11. Tachometer
12. Clock
Displays the current set time.
Coolant temperature reminder, when the water temperature
13. Water temperature
indicator light turns red
gauge
If the red light comes on, stop the vehicle and check immediately.
When the vehicle speed is greater than 15km/h, blind spot
monitoring and lane change
14. Right blind spot The auxiliary function is activated and an alarm is sounded when
monitoring
there is a vehicle behind you on the right.
Functional Description
"The lights flash.
The indicator light stays on; when the
(when the voltage is low, the
"The lights flash.
on.