Installing The Battery - APRILIA RSV MILLE - PART 2 2000 Manual

Carefully read p. 93 (BATTERY).
Make sure that the ignition switch is in
position " ".
Remove the rider saddle, see p. 76 (RE-
MOVING THE RIDER SADDLE).
96
use and maintenance RSV mille - RSV mille R
NOTE
The battery (1) must be posi-
tioned in its compartment with the termi-
nals directed towards the rear part of the
vehicle.
Put the battery (1) in its compartment.
Put back the bracket (2) that locks the
battery.
Screw and tighten the screw (3).
WARNING
Upon reassembly, connect first the pos-
itive cable (+) and then the negative ca-
ble (–).
Connect the positive terminal (+) by
means of the screw (4).
Connect the negative terminal (–) by
means of the screw (5).
Cover the terminals of the cables and of
the battery with neutral grease or vase-
line.
Put back the red protection element (6).
Put back the rider saddle, see p. 76 (RE-
MOVING THE RIDER SADDLE).
CAUTION
To remove the battery it is necessary to
set to zero the digital clock and the red
line setting. To reset these functions,
see p. 20 (MULTIFUNCTION COMPU-
TER).