APRILIA RSV MILLE - PART 2 2000 Manual page 15

OK ! OK !
A A
NO! NO!
CAUTION
Before proceeding with the reassembly,
make sure that support plate (12) of the
brake caliper (13) is positioned correct-
ly; the plate slot must be inserted in the
appropriate stop pin (17) in the inner
part of the rear fork right rod.
Insert the disc in the brake caliper care-
fully.
Position the wheel between the rear fork
rods on the support (2).
WARNING
Do not introduce your fingers between
the chain and the crown gear.
Make the wheel advance and position
the drive chain (8) on the crown gear (9).
Correctly insert the right (6) and left (7)
chain tighteners in their seats on the
fork.
Uniformly apply a moderate quantity of
OK ! OK !
OK ! OK !
B B
9
grease on the wheel pin (5), see p. 113
(LUBRICANT CHART).
WARNING
Danger of injury.
Do not introduce your fingers to align
the holes.
Move the wheel backwards, until its cen-
tral hole and the holes on the rear fork
are aligned.
Rotate the support plate (12), complete
with brake caliper (13) and with fulcrum
on the stop pin (17), until it is aligned with
the holes.
Introduce the wheel pin (5) completely
from the left side.
NOTE
Make sure that the wheel pin (5)
is completely inserted, with the head in the
relevant seat on the left chain tightener (7).
Position the washer and tighten the
wheel nut (3) manually.
NO! NO!
C C
9
Check the chain tension, see p. 74
(DRIVE CHAIN).
Tighten the wheel nut (3).
Wheel nut (3) driving torque: 120 Nm
(12 kgm).
Make sure that the following components
are not dirty:
– tyre;
– wheel;
– brake discs.
CAUTION
After reassembly, pull the rear brake le-
ver repeatedly and check the correct
functioning of the braking system.
Check the wheel centering.
Have the driving torques, centering and
balancing of the wheel checked by your
Official Dealer, in order to avoid
accidents that may be harmful for you
and/or other people.
use and maintenance RSV mille - RSV mille R 73