NOTE
To check the direction of the
headlight beam, specific procedures must
be adopted, in accordance with the regula-
tions in force in the country where the vehi-
cle is used.
I
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
100
use and maintenance RSV mille - RSV mille R
To adjust the headlight beam:
Position the vehicle on the stand, see p.
58 (POSITIONING THE VEHICLE ON
THE STAND).
Working on the rear left side of the front
part of the fairing, adjust the appropriate
screw (1) by means of a short cross-tip
screwdriver.
– By SCREWING IT (clockwise), you set
the beam upwards;
– By UNSCREWING IT (anticlockwise),
you set the beam downwards.
After the adjustment:
WARNING
Make sure that the vertical adjustment
of the headlight beam is correct.