Removing The Drive Chain Guards; Installing The Side Bag Supports (Supplied As Standard Equipment In The Countries Where Required); Installing The Rear Case Supports - APRILIA PEGASO 650 IE - 2004 Manual

3
REMOVING THE DRIVE CHAIN
GUARDS
Carefully read 51 (MAINTENANCE).
u Position the vehicle on the stand, see p.
49 (POSITIONING THE VEHICLE ON
THE STAND).
u Unscrew and remove the two screws (1).
u From the opposite side, unscrew and
remove the screw (2).
66 use and maintenance Pegaso 650 I.E.
1
4
5
H a n d l e t h e p l a s t i c a n d p a i n t e d
components with care to avoid scraping
or damaging them.
u Lift and remove the upper guard (3).
u Unscrew and remove the two screws (4).
u Remove the lower protection element
(5).
3
2
CAUTION
INSTALLING THE SIDE BAG
SUPPORTS (supplied as
standard equipment in the
countries where required)
NOTE
If also the rear case supports
must be installed beside the side bag
supports, it is necessary to install the
former first, see p. 68 [INSTALLING THE
REAR CASE SUPPORTS
standard equipment in the countries where
required)].
Carefully read 51 (MAINTENANCE).
T h e f o l l o w i n g p a r t s a r e s u p p l i e d
together with the side bag supports:
– four screws T.E. M8 x 20 (1) (2) with the
relevant washers (3) (4);
– two screws T.C.E.I. M8 x 20 (5);
– two screws T.C.E.I. M8 x 30 (6);
– two spacers (7);
– two front couplings (8);
– two rear couplings (9).
(supplied as