Extended S-Registers "Atsn=X; Table 6-2 Extended S-Registers - ZyXEL Communications U-90E User Manual

U-90E Data/Fax Modem
Command Function & Description
S6= Set the number of seconds the modem waits before
dialing if 'X0' or 'X1' is selected. If a setting of 'X2' to
'X7' is selected, the modem will dial as soon as it
detects a dial tone. This register also sets the time-
out interval for the "W" dial modifier to wait for the dial
tone. (See also S41b4)
S7= Set duration, in number of seconds modem waits for
a carrier
S8= Set duration, in seconds, for pause (,) option in Dial
command and pause between command re-
executions for Repeat (>) command
S9= Set duration, in tenths of a second of remote carrier
signal before recognition (Ignored if in non-FSK or
half-duplex operation)
S10= Set duration, in tenths of a second, modem waits
after loss of carrier before hanging up
S11= Set duration and spacing, in milliseconds, of dialed
Touch-Tones

6.1.2 Extended S-Registers "ATSn=x"

Command bit dec
S13= bit dec
1 2
S14= bit dec
0 0
1
6-2

Table 6-2 Extended S-Registers

hex Function and description
hex Bit-mapped register
2 Capture modem manufacturer
information during V.42 handshake,
can be displayed at ATI2 <Last
Speed/Protocol> line if available
('Flash' or ' ZyXEL' stands for ZyXEL
connection)
hex Bit-mapped register:
0* Originate mode auto handshake in
leased line mode.
1 Answer mode auto handshake in
leased line mode.(Default)
+Ref.
+003
+060
+002
+006
+007
+070
Ref.
+000
+002
*M0
*M1
Status Registers