Table 10-2 At*Rab Command; Table 10-3 At*Wab Command - ZyXEL Communications U-90E User Manual

U-90E Data/Fax Modem
Local profile modification is done by loading the remote profile as the active settings and
then modifying and saving the active settings back to the profile. Then the connection is
reestablished and the profile transmitted to the remote modem.
Reading a remote profile b into a local profile a is achieved with the command:
A=0-3
b=0-3
b=4
b=5
Uploading (writing) the local profile to the remote modem's profile and making the remote
modem reset its profile from the new profile is achieved with the command:
The remote profile read and write commands - *Rab and *Wab - only work in the on-line
condition. The connection speed and mode do not matter.
Before doing remote configuration the remote modem must be set to accept remote
configuration by executing the
digital loopback mode to request remote configuration information, the remote digital
AT&T4
loopback request (
remote configuration request. The
configuration requests.
10-4

Table 10-2 AT*Rab Command

Local user profile number.
Remote user profile number.
Remote active configuration.
Remote factory default.

Table 10-3 AT*Wab Command

a=0-3 Local user profile number.
a=4 Local active configuration.
a=5 Local factory default.
b=0-3 Remote user profile number.
AT*F1
command. Also as the modem uses the remote
) must also be granted on the remote modem to accept the
AT*F0
command will set the modem to deny remote
AT*Rab
AT*Wab
Special Functions